Apc Network Management Device Ip Configuration Wizard Download

17-08-2021 by

If you can’t set the IP address on a APC Management Card using the IP Configuration wizard, you can follow these steps to set it manually. For example, you want to set the IP address 192.168.1.10 on a Management Card with 00-a1-b2-c3-d4-e5 MAC address.

  1. On your Windows machine, start command prompt and type: C:>arp -s 192.168.1.10 00-a1-b2-c3-d4-e5
  2. Type: C:>ping 192.168.1.10 -l 113
  3. Now you can use Telnet or your Internet browser to finish the configuration (Default Gateway, subnet etc.) of the APC Management Card. The default user/password is apc/apc.
Network management device ip configuration wizard

Note: your Windows machine and the APC Management Card must be on the same subnet.

ConfigurationDownload

The Wizard can discover and configure Network Management Cards only if they are on the same network segment as the computer that is running the Wizard. APC Device IP Configuration Wizard Free Download Information: Free Download 64 is not responsible for software you are downloading nor for details provided about the software 'APC Device IP. American Power Conversion (APC) is a leading manufacturer of uninterruptible power supplies (UPS) and surge protection products for end-to-end legendary reliability. Download APC Device IP Configuration Wizard for free. APC Device IP Configuration Wizard - You can use the APC Device IP Configuration Wizard to configure the basic TCP/IP settings (IP address, subnet mask, and default gateway) of the following: - Network Management Cards - Devices that contain embedded Network Management Cards Using the Wizard.

Network Management Device Ip Configuration Wizard V5.0.3

Source:APC Installation and Quick-Start, Network Management Card.

Cheers!

– Marek.Z

The Device IP Configuration utility supplied by APC can also apply IP addresses to NMCs, however, this method is unreliable, often not finding NMCs and when it does, not always successfully applying the IP Address. The below steps cover how to configure the NMC IP address using the serial cable supplied with the card itself.
  • Remove all loads from the UPS.
  • Turn off the UPS (Power button, front panel)
  • Remove mains power from UPS
  • Hold down power button (front panel) for 5 seconds to disconnect battery.
  • Remove back panel where NMC is to be installed.
  • Install NMC
  • Plug UPS back into mains
  • Connect Serial cable that came with NMC
  • Attach to laptop
  • Download and run PuTTY – Telnet Client (or any alternative)
  • Connect with the following settings
    • Bits per second 9600
    • Data Bits 8
    • Parity None
    • Stop bits 1
    • Flow Control None

Apc Network Management Device Ip Configuration Wizard Download Windows 7

  • Connect and press enter until you are prompted for a username
    • Username: APC
    • Password: APC

Network Management Device Ip Configuration Wizard

  • Set IP Address using the following commands;
    • apc> tcpip -iyourIPaddress-syourSubnetMask -gyourDefaultGateway
    • apc> reboot
Example;

Apc Device Ip Configuration Wizard Download

apc>tcpip-i159.216.45.39-s255.255.254.0-g159.216.45.1

Network
The NMC will now reboot and the IP address should be configured. To test, browse to the IP Address and see if the NMC web interface loads.

81 Tiles Mod
Fortune Days The Glitch Mob Zippy Music

Comments are closed.